Concrete Cutting and Core Drilling Cost Guide for Fort Wayne, IN
How contractors price each service
| Service | Usually priced by | Biggest cost drivers |
|---|---|---|
| Core drilling | Per hole, plus minimum or trip charge | Diameter, depth, rebar, number of holes, overhead work |
| Slab sawing | Per linear foot, by depth | Slab thickness, reinforcement, indoor vs outdoor, removal |
| Wall sawing | Per linear foot or per opening | Wall thickness, track setup, access to both sides, removal |
| Wire sawing | Per square foot of cut face, plus setup | Section thickness, rebar density, access for drive and pulleys, lifting and haul-off |
| GPR scanning | Per visit or per area | Area scanned, number of locations |
Ways to lower your cost
- Group all holes and cuts into one visit to avoid paying the minimum charge twice.
- Mark exact locations and sizes before the crew arrives.
- Clear the work area and confirm water and power access.
- Ask whether removal and haul-off is included or priced separately.
Checklist before you request a quote
- Type of work: core holes, slab cut or wall opening
- Sizes: hole diameters and count, or cut length and depth
- Concrete thickness and any known rebar or post-tension
- Indoor or outdoor, which floor, and access
- Whether utilities could be in the concrete
- Your timeline
Cost questions
How much does concrete core drilling cost in Fort Wayne?
Core drilling is usually priced per hole, by diameter and depth, plus a minimum charge or trip fee per visit. Small holes through a standard 4 to 6 inch slab are the least expensive; large diameters, thick walls, heavy rebar and overhead drilling cost more. A single small hole can cost close to the minimum charge, so batching holes saves money.
How much does slab sawing cost in Fort Wayne?
Slab sawing is usually priced per linear foot, and the rate rises with depth. Thin control-joint cuts are the cheapest per foot; full-depth cuts through thick or reinforced slabs cost more. Breaking out and hauling away the cut concrete is typically a separate line item.
Why is wall sawing more expensive than slab sawing?
Wall sawing needs a track bolted to the wall, slower vertical cutting and water control running down the wall face. Setup is a large share of the cost, so short cuts cost more per foot than long ones.
What adds cost to a concrete cutting job?
Thicker concrete, dense rebar or post-tension cable, overhead or tight-access work, no water or power on site, GPR scanning, after-hours scheduling, and removal and disposal of the concrete.